Using ndiswrapper, could not load. It stays active for a few minutes, then drops the connection, cycles back to the passphrase request and then the cyce starts all over again. The p54 driver loads when I plug in the adpater. Linux – Newbie This Linux forum is for members that are new to Linux. Join Date Dec Beans After rebooting, I selected the network icon in the upper panel by right clicking.

Uploader: Vikazahn
Date Added: 10 February 2005
File Size: 38.76 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 89678
Price: Free* [*Free Regsitration Required]

Using the Linksys WUSB54G (v1 or v4) With Ubuntu Gutsy

I also tried the “sudo apt-get install linux-firmware- nonfree” suggestion and it made no difference. For the selected connection type there was no active network interface found on your system!!! Works “out of the box” in Karmic. The following lines are desirable for IPv6 capable hosts:: After doing the commands, but before reboot, the wlan0 was still not visible in iwconfig. Thanks you very much.


Yes In Ubuntu Page History Login to edit. Yes Tested on Dapper Beta 2.

Okay, here are the steps. Is not detected by Jaunty. Please reopen if this is still an issue in the current Ubuntu release http: Sign up using Facebook. Brian, I have the same problem adapter is v4. Just starting out and have a question?

Matt, Not sure—you might try the Ubuntu forums on that one. Wednesday, August 11,6: This is with eth0 working and after yet another failed attempt to get wlan0 with iwconfig, etc. Dave, Do you have any suggestions? Any advice, help or directions you can give linsys or refer me would be much appreciated. Leave a reply Cancel reply Comment.

As a linkys this bug is being closed. Thank you for taking the time to report this bug and helping to make Ubuntu better. You can determine the version by looking on the bottom of the adapter.

HOWTO setup Linksys WUSB54G V4 wireless in Ubuntu Gusty | Ubuntu Geek

To do this when Ubuntu starts, open the restricted drivers management and enable bcm43xx. If it is not in the man wusb554gs or the how-to’s this is the place!


Join our community today! I went into my router configuration and I changed the 2.

Visit the following links: There is no wlan listing at all. Since Adrien has now downgraded back to 9. Go ahead and stick your head in the sand.

HardwareSupportComponentsWirelessNetworkCardsLinksys – Community Help Wiki

Please visit this page to clear all LQ-related cookies. By using our site, you acknowledge that you have read and understand our Cookie PolicyPrivacy Policyand our Terms of Service. Linux – Newbie This Linux forum is for members that are new to Linux. Linkssys Support Community Ubuntu.